?
全国销售热线:

17751621770

资讯资讯
电动葫芦您的位置:电动葫芦 > 资讯资讯 >

防爆电动葫芦安装防爆装置

2016-07-01 17:17

浏览次数: 文章来源: admin

防爆电动葫芦的防爆特性主要是由其防爆电机决定的,需要注意以下几点:
The explosion-proof characteristic of explosion-proof electric hoist is mainly determined by the explosion proof motor, and the following points should be paid attention to:
1、拆卸电机时,先取下风罩、风扇,再用套管板手拆卸端盖和轴承盖螺栓,用圆木沿轴向撞击轴伸,使端盖和机座分开取下转子。
1, when disassembling the motor, preempt the lee cover, fan, and then the casing plate hand removal of end cap and a bearing cover bolts and logs were used along the axial impact shaft extension, the end cover and stand apart from the rotor.
2、拆除防爆葫芦零件,防爆面应朝上搁置,并用橡皮或布衬垫盖上,紧固螺栓,弹簧垫等注意不要丢失。
2, remove the explosion-proof hoist parts, explosion-proof surface should be put on hold, and with rubber or cloth cover, tighten the bolt, spring, and so do not lose the attention.
3、浸漆和组装时,应将防爆面附着的绝缘漆或脏物清洗干净,不得用铁片等硬物刮划,但可以用油石研磨不平整的地方。
3, dipping paint and assembly, should will explosion-proof surface attached to the insulation paint or dirt clean, not with iron hard scratching, but can with an oilstone grinding uneven.
4、防爆电动葫芦电机拆卸检修时,不能用零件的防爆面作撬棒的支点,更不允许敲打或撞击防爆面。
4, explosion-proof electric hoist motor disassembly and maintenance, cannot use parts of the explosion-proof surface as lever fulcrum, but does not allow to strike or hit the explosion-proof surface.
?

全国咨询热线:400 888 2742 手机:17751621770 电话:0523-84873548 传真:0523-84633319 地址:江苏省靖江市斜桥镇江平路18号 网站地图

网站制作、SEO网站优化、高端网站建设、引擎技网络

XML 地图 | Sitemap 地图